Fly DS400: About SIM Card and the Battery

Fly >> Fly DS400 >> About SIM Card and the Battery

About SIM Card and the Battery

Please store the cards out of the reach of children.
The cards and the contacts are vulnerable to damages due to scratching or bending.
Therefore, be careful when using, inserting or removing the cards.
Be sure to switch off the phone before you insert or remove the battery or the cards, otherwise, the phone may be damaged.

To insert SIM card and battery

1. Insert the card in the slot in the direction indicated by the arrow. (Left: the card slot for Master SIM. Right: the card slot for Slave SIM.) Please insert the card with the metal contact of the card facing downwards.

2. Insert the battery.

3. Replace the battery cover.

Tip: Be sure to use the original battery.

To remove the battery and SIM card

1. Switch off the phone.
2. Push and remove the battery cover.

3. Remove the battery.

4. Push out the card from the slot with a finger in the direction indicated by the arrow.
(Left: the card slot for Master SIM. Right: the card slot for Slave SIM.)

To remove the Micro SD card

1. Open the Micro SD card slot cover on the bottom-left corner of the phone.
2. Push inwards the Micro SD card with the fingertip and release, and the Micro SD card will be ejected.

3. Pull out the Micro SD card.

Tip: When any application of the phone or the Micro SD card is running, do not insert or pull out the Micro SD card, otherwise, data may be lost or the Micro SD card may be damaged!

To insert the Micro SD card

1. Push the Micro SD card in the direction indicated by the sign printed on the card into the card slot of the phone, with the metal contact of the card facing down.
2. Replace the Micro SD card slot cover.

Tip: Some Micro SD Cards have poor compatibility. Please buy and use tested and certified Micro SD cards.

To charge the battery

1. Insert the plug of the charger into the interface of the phone, and insert the charger into the power socket carefully. The battery icon will blink.

2. The red light is lit during charging. When the battery icon stops blinking or the green light is lit, it indicates that the charging is finished.

3. After the charging, unplug the charger from the socket, and press and hold the left and right buttons on the plug of the charger to pull out the plug from the phone.

Tips:
The battery icon

displayed on the screen indicates that the battery power is low.
Please charge the battery following the steps above.
Please charge the battery before you use the newly bought phone. We suggest you charge the battery for 4 hours continuously for the first time.
Charging when the phone is in the ON mode will not influence the normal dialing and answering, but this needs to consume power, thus the time of charging will increase.
We suggest you recharge the battery when the power is used up so as to prolong the life of the battery.