Getting Started
YOUR FIRST CALL
Please refer to the following diagram that describes the
main steps to make a first call.
INSERT A SIM CARD
(Phone is switched off and battery should be removed)
CHARGE THE BATTERY
SWITCH THE PHONE ON/OFF
ENTER YOUR PIN(ACCESS CODE - IF ACTIVATED)
DIAL THE PHONE NUMBER REQUIRED
WHEN FINISHED, END THE CALL
INSTALLING THE SIM CARD
When you subscribe to a cellular network, you will need a
plug-in SIM card loaded with your subscription details (PIN,
and optional services available).
1. If necessary, switch off the phone by holding down the
End/Power key until the Power off message appears.
2. Remove the battery by following the steps below:
- Slide down the battery cover on the back of the phone.
- Lift the battery, as shown below.
3. Put the SIM card into the phone. Ensure that the SIM card is inserted
properly.
4. Place the battery pack inside the phone. Slide in the battery cover to the
phone.
CHARGING THE BATTERY
Your phone package comes with a battery, and a travel
charger. You can also use USB data cable to charge your
phone, however, the charging time may be different from
travel charger.
Use only Fly approved batteries and chargers for your
safety.
Note: It is highly recommended to fully charge the
battery prior to using your phone for the first time
1. After properly putting the battery in the phone, insert
the charging plug into the charging port at the “left side”
of the phone.
2. Connect the travel charger to a standard AC outlet.
3. When charging is complete, disconnect the travel
charger from the power outlet and the phone by pulling
out the charging plug.
Note: When the battery is discharged completely, and
not used for a while, the phone will not display the
charging icon for about 30 minutes while charging. After
30 minutes of charging, the phone will display the
charging icon.
SWITCHING THE PHONE ON/OFF
1. Hold down the power on/off key for more than one
second to switch on.
2. If the phone asks for a PIN, key-in the PIN. The
phone searches for your network and when detected,
will display the idle screen. The external display shows
the signal strength, battery strength and current time
and date.
3. When you wish to switch off the phone, hold down the
power on/off key for more than two seconds.
ACCESS CODES
There are access codes for your SIM card. These codes
help you to protect the phone against unauthorized use.
When requested for any of the code explained below, keyin
the appropriate code (displayed as asterisks) and press
the OK key.
PIN
The Personal Identification Number or PIN (4-8digits)
protects your SIM card against unauthorized use. The
PIN comes with the SIM card; see the SIM card
instruction provided with your card.
If you enter an incorrect PIN three times in succession,
the code will be disabled and cannot be used until you
re-enable it by entering the PUK.
PUK
The 8-digit PUK (Personal Unblocking Key) is required
to change a disabled PIN. The PUK may be supplied
with the SIM card. If not, or in case you have lost it,
please contact your service provider.
To re-enable your PIN, proceed as follows.
1. Key-in the PUK and press the OK key.
2. Enter a new PIN of your choice and press the OK
key.
3. When the Confirm New PIN message is displayed,
key-in the same code again and press the OK key.
If you enter an incorrect PUK ten times in succession,
the SIM card becomes invalid. Please contact your
service provider for a new card.
Pin Password
The 4 ~ 8 digits of password is required when you use
the Call barring function. You can obtain the password
from your service provider when you subscribe to this
function.
