Getting started
Set-up
Removing/Replacing the back cover
Installing/Removing the battery
Insert and click the battery into place, then close the telephone cover.
Unclip the cover, then remove the battery.
Inserting/Removing the the SIM card
You must insert your SIM card (1) to make phone calls.
(1) Check with your network operator to make sure that your SIM card
is 3V compatible.The old 5 Volt cards can no longer be used. Please
contact your operator.
Place the SIM card with the chip facing downwards and slide it
into its housing. Make sure that it is correctly inserted.
To remove the card, press it and slide it out.
Charging the battery
Connect the battery charger
• The charging may take about 20 minutes to start if the battery is flat.
• Be careful not to force the plug into the socket.
• Make sure the battery is correctly inserted before connecting the charger.
• The mains socket must be near to the phone and easily accessible (avoid
electric extension cables).
• When using your telephone for the first time, charge the battery fully
(approximately 3 hours). You are advised to fully charge the battery (
).
The charge is complete when the animation stops. Only use
Alcatel chargers.
Power on your phone
Hold down the 
key until the telephone
powers on, type in
your PIN code if necessary and then confirm with the
key.
The main screen is displayed.
If you don’t know your PIN code or if you have forgotten it,
contact your network operator.Do not leave your PIN code near
your telephone and store your card in a safe place when not in
use.
If cell broadcast messages are displayed, use the
key to
browse through them in full or press the right softkey to return to the
main screen.
While the phone is searching for a network, “Searching/Emergency”
will be displayed.
Power off your phone
Hold down the key from the main
screen.
